Napco Security Technologies GEM-DXRP2 Instrukcja Użytkownika Pobierz pdf (Strona 13)

FIRE PROTECTION

(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)

Fire-Zone Alarm

If a fire is detected, “reset FIRE ALARM” will be displayed and the keypad sounder will

pulse.

1. If a fire is in progress, evacuate the premises immediately! If necessary, call the

Fire Department from an outside phone.

2. Press the C button to silence the keypad sounder.

3. If there is no evidence of a fire, enter your User Code and press J to turn off the

alarm.

4. Check smoke detector(s). If a smoke detector tripped, its red alarm indicator light

will be on.

After the alarm condition is corrected (thermostat cooled down; smoke cleared from

detector; etc.), pressing

C again will reset the keypad within about 10 seconds.

Fire-Zone Trouble

If a problem in the fire-circuit is detected, “TROUBLE” (fire trouble) will display and

the sounder will pulse to signal a malfunction.

2. Press C to silence the sounder. Call for service immediately!

reset FIRE ALARM

AC ON

FIRE/

ZONEXX

TROUBLE

AC ON

TRBL/

E41-XX

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Brak uwag

Napco Security Technologies GEM-DXRP2 Instrukcja Użytkownika Strona 13